If it does not trigger, the macro group might also need to be ENABLED. Note: This macro was uploaded in a DISABLED state. Since pmset must be run as root to modify settings, the crontab command should be used as follows: sudo crontabįor example, if this template is copied to create macros that trigger 2:00, 3:00, and 4:00 a.m., the root contab file should be set as pmset repeat wakeorpoweron MTWRFSU 01:59:00Ġ 2 * * * pmset repeat wakeorpoweron MTWRFSU 02:59:00Ġ 3 * * * pmset repeat wakeorpoweron MTWRFSU 03:59:00Ġ 4 * * * pmset repeat wakeorpoweron MTWRFSU 01:59:00 TESTED WITH If more times are needed, the command pmset can be used in combination with cron. System Preferences > Energy Saver (or Battery) > Schedule > Start up or wake can be used to schedule only one startup time per day. In the former case, the Mac will be put the Mac to sleep unless another instance of this macro is started before this macro completes. any other configured trigger is detected (e.g., ⌃⌥F2).This cron entry matches the current time, OR.The macro template includes actions that will run when: I stripped out the tasks and created this template that you might want to try. to do some routine tasks using Keyboard Maestro. Hi I have an old headless Mac mini that I wake at 2:00, 3:00, and 4:00 a.m. If the Mac was running on battery then waking from sleep to perform an actions periodically could easily drain the battery. There are no current plans to have Keyboard Maestro automatically wake from sleep to perform macros, because that could easily be more of an issue than not doing that. And even if it is not asleep, most UI actions cannot work while the Mac is screen locked, screen saving or screen sleeping. Network changes, Idle triggers, periodic triggers, cron triggers, USB Device Key triggers, none of them will work if the Mac is asleep, or if the Mac is turned off. This applies to all triggers, not just time based ones. Keyboard Maestro is not running when the Mac is asleep, so no triggers will operate. Personally, my Mac has had sleep disabled for decades to allow it to backup or perform tasks at night.īut in any event, all triggers have various limitations and they cannot all be covered directly in the UI without adding a lot of clutter. With the screen slept, the Mac not sleeping is unlikely to use a substantial amount of energy while doing not much. Enable system to wake from S5 using RTC alarm. Noted, but I disagree that it is a huge limitation worthy of inclusion in the display. U.FL external clock input connector for the system and Ethernet. It's a huge limitation that makes KM very expensive to run, as I can no longer allow my Mac to sleep. The Wiki documents that, if the Mac is asleep when a timed macro is triggered, the macro will not run, but I believe that's important enough that it should appear on screen in the app when a timed trigger is selected.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |